A lily flower with a central pistil surrounded by stamens. The six orange structures are pollen-laden anthers, each borne at the end of a stalk known as a filament. (more)

Undoubtably, your petals will now be slightly overlapping due to the copper being spread out slightly over those cuts you made. This will prevent us from shaping them easily, so we want to remove that overlap - simply use your tinsnips to make those cuts again, in the same places, and the overlap will drop off and the petals should be nicely separate. Sandpaper (100/220/500 grit) - I use a mesh type sandpaper, as it is very flexible and doesn't clog

Bulrushes Copper Fountain

I used a metal adhesive for outdoor use to glue the flowers together. This glue requires mixing two substances together and then working within 5 minutes. Use proper safety protection like gloves and a mask when working with chemicals like this.

Now, flip the hammer over so you're using the crosspeen head. Begin to strike the edges of the petals, to create a series of radial indents that all point towards (or thereabouts) the centre of the petal. This gives each petal a nice texture. Don't worry about texturing the centre of each petal, as it won't be seen. It's important to be brave here and strike quite forcefully - you're looking for something that looks like this: These splendid copper colored leaves really bring in the outdoors. The rusty bronze hues work well in flower arrangements.

Bring the copper up to temperature slowly by putting it under the flame for 1/2 second at a time. You can tell it's up to temperature when you remove the flame and start to see colors form on the copper. There are also three petals that are narrower than the sepals. The sepals and the petals are all copper colored. The sepals are usually a lighter yellow near the base and they don’t have hairs at the base. 2. Copper Cushion Flower

One look at the beautiful hue of this rose and you just know you have to have it! The color is divine and would grace any surroundings with a warm and pleasant glow. 13. Copper Rose Sculpture Steel M6 hex nuts - very common, and very cheap. Keep a couple spare, in case something goes wrong.

Securely hold the copper using pliers (the larger the better) and make sure the area is clear from any potential fire hazards Now, take the left hand edge of one of the petals in your pliers and bend it in towards the petal to it's left. This should give it sort of a C shape when looking at it from the top. Do the same with the remaining petals and they all should be wrapping around each other. If they are still too wide, use your regular pair of pliers to squish them together in a tighter spiral. The colors achieved using an oven vary with the temperatures and exposure times. My results were as follows, but expect variations with your specific oven.